27 10 020 Installing exchange transfer box (ATC 45L)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before and after replacement, execute the "Repair" service function with the BMW diagnosis system.
Recycling:
Catch and dispose of escaping transmission oil. Observe country-specific waste disposal regulations
Necessary preliminary tasks:
- Drain GEAR OIL at oil drain plug.
Tightening torque 27 10 2AZ .
- Remove TRANSFER BOX .
Remount the following parts:
- Covers and protective caps
- Drive shaft transportation retainer
- Vent hose of transfer box.
- REPLACE RUBBER MOUNT FOR TRANSFER BOX MOUNTING IF REQUIRED .
IMPORTANT:
After completing work, check gear oil level and top up if necessary.
Undo oil filler plug (1).
Check oil level.
Tightening torque 27 10 2AZ .
Top up transmission oil up to lower edge of opening for oil filler plugs (1).
Use only approved GEARBOX OIL .
Undo oil filler plug (1).
Check oil level.
Tightening torque 27 10 2AZ .
Top up transmission oil up to lower edge of opening for oil filler plugs (1).
Use only approved GEARBOX OIL .
Failure to comply with this requirement will result in serious damage to the transfer box.
After replacement:
Repair service function CARRY OUT PROGRAMMING/ENCODING .