LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> X3 M40i >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Seats - Repair) >> Rear Seat, Through-Loading >> 52 26 315 Removing and refitting/replacing lock for center rear seat backrest

52 26 315 Removing and refitting/replacing lock for center rear seat backrest

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Unclip trim cover for lock with a plastic wedge.

Move trim cover for lock a little towards the middle.

Detach trim cover for lock by pulling towards rear.

Fig 1: Removing Trim Cover Using Plastic Wedge
G09949057Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Retaining lugs on the trim cover for the lock must not be damaged.

Replace defective trim cover for lock.

Fig 2: Identifying Cover Retaining Lugs
G09949058Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and feed lock (2) out of rear seat backrest.

Tightening torque 52 26 11AZ .

Fig 3: Identifying Rear Seat Backrest Lock With Screws
G09949087Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure operating rod (1) is correctly seated in the lock.

Run a function check.

Fig 4: Identifying Operating Rod
G09949088Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals