52 26 310 Removing and installing/replacing lock for right rear seat backrest

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Gently slide lock finisher (1) on side edge of backrest downwards and unclip to one side.

Gently slide lock finisher on rear side towards middle.

Unclip and remove lock finisher.

Fig 1: Removing Lock Trim

G05507192

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs on cover must not be damaged.

Fig 2: Locating Retaining Lugs On Cover

G05507193

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Insert plastic wedge from outside between cover (1) and lock.
Carefully lever outer side of cover (1) with plastic wedge upwards out of catch.
Lever inner side of cover (1) with plastic wedge out of catch.
Remove cover upwards.

Fig 3: Inserting Plastic Wedge Between Cover And Lock

G04792103

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out backrest cover (1) in working area.

Fig 4: Removing Backrest Cover

G04792104

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and feed door lock (1) out of rear seat backrest.

Tightening torque 52 26 11AZ .

Fig 5: Locating Door Lock Backrest Screws

G04792105

Courtesy of BMW OF NORTH AMERICA, INC.