52 26 206 Removing and installing/replacing rear panel on left rear seat backrest with through-loading system

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Depending on equipment specification:

Ohne SA 413: Unclip cover (1) for combined roller cover mount.

Mit SA 413: Unclip trim cover for combined roller cover mount.

Fig 1: Identifying Cover For Combined Roller Cover Mount

G09949063

Courtesy of BMW OF NORTH AMERICA, INC.

With option SA 413:

Release screws (1).

Tightening torque 52 26 9AZ .

Remove mount for combined roller cover.

Fig 2: Identifying Combined Roller Cover Screws

G09949064

Courtesy of BMW OF NORTH AMERICA, INC.

Gently slide lock finisher (1) on side edge of backrest downwards and unclip to one side.

Gently slide lock finisher on rear side towards middle.

Unclip and remove lock finisher.

Fig 3: Removing Lock Trim

G05507192

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs on cover must not be damaged.

If necessary, replace faulty cover.

Fig 4: Locating Retaining Lugs On Cover

G05507193

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out welt in marked area from backrest frame.

Remove rear panel from backrest frame.

Fig 5: Removing Rear Panel From Backrest Frame

G04727365

Courtesy of BMW OF NORTH AMERICA, INC.