52 26 012 Removing and installing/replacing backrest for right rear seat

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Remove ARMREST SIDE SECTION

Lift out pin and remove expanding rivet (1).

Unfasten screws (2).

Tightening torque 52 26 01AZ .

Fig 1: Locating Expanding Rivet And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Tilt backrest slightly forwards.
Pull backrest forwards and outwards out of center mount

Fig 2: Pulling Backrest Outwards Out Of Center Mount
Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure plastic bush (1) is fitted correctly in the center mount.

The plastic bush (1) must be retained in the center mount with a lug.

Fig 3: Locating Plastic Bush

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure plastic bush (1) is fitted correctly in the backrest frame.

The plastic bush (1) must be retained in the backrest frame with a lug.

If applicable, PARTIALLY REMOVE THE BACKREST COVER and clip the plastic bush (1) in from the outside in.

Fig 4: Identifying Plastic Bush

Courtesy of BMW OF NORTH AMERICA, INC.