52 14 392 Removing and installing/replacing front left or right crash-active head restraint (from 09/08)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe SAFETY REGULATIONS when handling airbag modules.
Incorrect handling may result in triggering of the crash-active headrest and thereby cause injury.

Switch off the ignition!

Necessary preliminary tasks:

Disconnect NEGATIVE BATTERY CABLE
Remove REAR PANEL

Starting situation:

Head restraint is in the crash position after being triggered.

A triggered head restraint can be recognized by the padded section which has moved upwards.

Fig 1: Identifying Activated Head Restraint

G08486395

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip PLUG CONNECTION (1) for crash-active headrest from holder.

Unfasten plug connection (1) and disconnect.

Fig 2: Disconnect Plug Connection

G06204261

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out sealing cap (1).

Fig 3: Identifying Protective Cap

G06204262

Courtesy of BMW OF NORTH AMERICA, INC.

Detach omega clip (1).

Fig 4: Detaching Omega Clip

G06204263

Courtesy of BMW OF NORTH AMERICA, INC.

Press latch mechanism (1) and lift out head restraint (2).

Fig 5: Lifting Out Head Restraint

G05779475

Courtesy of BMW OF NORTH AMERICA, INC.