67 31... Notes on initialization of electric seat actuator drives

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Initialization is carried out at the adjusting switch of the relevant seat.

In this process, the end positions of the relevant electric seat actuator drive are recorded and stored.

An initialization must be performed:

After replacing a drive unit for seat adjustment.
After replacing/programming control unit for seat adjustment.

Operating procedure for initialization:

Move corresponding seat actuator drive(s) into both end positions.