51 12 050 Removing and installing/replacing support for rear bumper panel
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove BUMPER PANEL
Release all nuts (1).
Tightening torque 51 12 1AZ .
Remove support (2).
Installation note:
Water ingress!
Bolts for nuts (1) must be sealed with SEALANT 1 towards tail panel.
Replace gasket between support (2) and body every time after dismantling.