51 45 069 Replace the decorative trim of the control panel

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary work:

Remove RADIO

Disconnect plug connection (1).

Unlock latch mechanisms (3) on the IHKA controls (2) by pressing the retaining tabs (3) inward with a suitable tool.

At the same time, press the IHKA controls (2) forward out of the holder frame and remove.

Installation note:

The IHKA control (2) must be felt and heard to engage in the retaining frame.

Fig 1: Locating IHKA Controls Latch Mechanisms

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs on trim cover (1) must not be damaged.

Fig 2: Locating Trim Cover Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock the retaining tabs (3) in the lower and side area of the radio control panel.

Remove radio control panel (1) from trim (4).

Installation note:

Retaining lugs (3) must not be damaged or missing.

Radio control panel (1) must noticeably and audibly engage in trim (4).

Fig 3: Identifying Radio Control Panel Trim And Retaining Lugs

Courtesy of BMW OF NORTH AMERICA, INC.