16 11 060 Removing and installing or replacing fuel filler pipe (petrol/gasoline)
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting vessel ready.
Catch and dispose of escaping fuel.
Observe country-specific waste disposal regulations.
Avoid skin contact (wear gloves)!
Before starting the engine for the first time:
- Fill fuel tank with at least 5 liters of fuel.
- Check ground connection at fuel filler neck to body for continuity. If necessary, clean contact surface between body and fuel filler pipe screw connection.
Necessary preliminary work:
- Extract FUEL from fuel tank.
- Remove REAR RIGHT WHEEL ARCH TRIM .
- REMOVE rear right underbody panelling.
Unhook retaining strap (1) from tank flap.
Open cap and set to one side.
Release hexagon nut (2).
Installation note:
Tightening torque: 16 12 2AZ .
Unclip line holder (1).
Release plastic nut (2).
Installation note:
Check plastic nut (2), replace if necessary.
Tightening torque: 16 12 2AZ .
Catch escaping fuel in a suitable container.
Release hose clamp (1) and remove fuel filler neck.
Installation note:
Check hose clamp, replace if necessary.
Tightening torque: 16 12 1AZ .
Replacement:
Release ear hose clamp (1).
Installation note:
Replace ear hose clamp
Detach filler hose (2) from fuel filler pipe (3).