61 31 082 Removing and installing/replacing switch for (left or right) central locking system

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

64 1 020

NOTE: When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged. If necessary, protect the working area with yellow plastic adhesive tape.

Removal:

Lever out trim (1) or tweeter speaker cover at front with special tool 64 1 020 .

Disconnect relevant connector and remove trim (1).

Fig 1: Identifying Trim/Tweeter Speaker Cover Into Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Unlock latch mechanisms on both sides.

Remove switch for central locking system (1) from trim.

Fig 2: Identifying Central Locking System From Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect corresponding connector.

Insert trim (1) or tweeter speaker cover into door trim panel.

Fig 3: Identifying Trim/Tweeter Speaker Cover Into Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.