61 35 196 Removing and installing (replacing) control unit for automatic operation of tailgate system
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Necessary preliminary work:
Unlock plug connections (1) and disconnect.
Feed out control unit (2) from holder (3).
Replacement:
Carry out VEHICLE PROGRAMMING/ENCODING .
NOTE:
From 03/2011, the control unit is installed with a different placement of connector chambers:
- Control unit to 03/2011
- Control unit from 03/2011
Replacement:
When control unit (2) is installed in vehicles with a production date up to 03/2011, the wiring harness (3) must be retightened.
NOTE:
Wiring harness length may vary dependent on the vehicle. If necessary, additional vehicle-specific work can be necessary.
Necessary preliminary work:
- If optional equipment installed: REMOVE AUTOMATIC SOFT CLOSE DRIVE .
- REMOVE BATTERY .
Release clip (1). Release adhesive tape (2) from wiring harness mounting (3). Retighten wiring harness in direction of the arrow until connector can be securely locked. Then secure wiring harness with adhesive tape to wiring harness mounting (3). Adapt clip (1) to new length and secure.
IMPORTANT:
Wiring harness may not be tensioned too tightly!