66 53... Instructions for adapting adjustment unit for reversing camera (CORGHI KDS quick-action clamp)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
The following operations should only be carried out when using the tool kit for calibrating the reversing camera for the first time.
NOTE:
The operation is described for the left-hand side; proceed in the same way for the right-hand side.
Remove support plate (1) from spindle (2).
Replace spindle (2) by spindle (3).
Press support plate (1) on to spindle (3).
Release retaining clip (1).
Remove ball pin (2) from rod (3).
Fit new ball pin (1) on rod (2) and secure with retaining clip (3).
Fit ball pin (1) on CORGHI KDS quick-release clamp and secure.
Remove all spacers (1) on cross bar (2).
NOTE:
Follow the same procedure for calibrating the reversing camera.