00 00... Work instruction for removing the protective film
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The protective film is applied to new vehicles at the works. The dealer must guarantee only expert removal of the protective film.
The protective film should be removed 48 hours before vehicle handover to the customer.
The protective film can be easily removed from the affected surfaces. Polishing is necessary only in exceptional cases.
Further information on the protective film is available in the information "Frequently asked questions on surface protection".
The protective film should be removed 48 hours before vehicle handover to the customer.
The protective film can be easily removed from the affected surfaces. Polishing is necessary only in exceptional cases.
Further information on the protective film is available in the information "Frequently asked questions on surface protection".
Instructions for removing the protective film:
- In order to reduce the amount of force required, the film can be torn at the edge and pulled off in narrower strips.
- Remove the film in a surface temperature range of -10 °C to +50 °C.
Excessively high temperatures can lead to adhesive residue being left on the surface.
In order to achieve the recommended temperature for pulling off the adhesive film from the vehicle after direct exposure to the sun, it is possible to carry out a car wash with applied protective film in order to cool the vehicle down.
Car wash and surface inspection:
- Check vehicle surface after the car wash.
- Any adhesive residue left on the vehicle surface can be removed by rubbing by hand or using a cleaning agent R2 (part number 83 19 0 417 324) or stain remover (part number 83 11 9 407 816) and a lint-free cloth.
Procedure in the event of paint swelling:
- Any paint swelling normally disappears within 48 hours.
- Higher temperatures (infrared lamp) accelerate this process.
- Polishing of the surfaces is necessary only in rare cases if the heat treatment does not result in success.