33 32 091 Replacing a control arm

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Release screw.

Tightening torque 33 32 4AZ .

Installation note:

Replace screw.

Tighten down screw connection in NORMAL POSITION .

Fig 1: Locating Control Arm Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: When installing, ensure that the tapered side of the bearing bush is connected first toward the wheel carrier.

Fig 2: Identifying Bearing Bush

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken nut (1).

Tightening torque 33 32 3AZ .

Unscrew bolt towards rear and remove control arm (2).

Installation note:

Bolt head must point to rear.

Replace screw and nut.

Tighten down screw connection in NORMAL POSITION .

Fig 3: Locating Control Arm

Courtesy of BMW OF NORTH AMERICA, INC.