11 61 350 Removing and installing/renewing pressure pipe on throttle body (N47 D20 O1)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Necessary preliminary work:
- Remove acoustic cover. See 13..... REMOVE ACOUSTIC COVER (N47 D20 O/T1) .
NOTE:
Lock (1) must snap into place in bracket (see arrow).
Release lock (1) with a suitable tool.
Disconnect pressure pipe (2) from charge air cooler.
Release lock (1) in direction of arrow.
Release pressure pipe (2) in direction of arrow.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Check sealing lip (1) for damage.
Installation note:
If sealing lip (1) is damaged, the seal must be replaced.
IMPORTANT:
In the event of a leak at the pressure pipe, there is a risk of damage
to the exhaust turbocharger.
Check sealing ring for damage.
Installation note:
If the sealing ring is damaged, the seal must be replaced.
Assemble engine.
Check differentiated air intake system for tightness.