11 00 039 Checking compression of all cylinders (N47 D20 O1)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
Necessary preliminary work:
- Remove all GLOW ELEMENTS .
WARNING:
On vehicles with manual gearbox:
There must be no drive position engaged during the starting operation.
There must be no drive position engaged during the starting operation.
IMPORTANT:
To prevent the injectors from injecting, it is necessary to disconnect the injection system plug connections.
Screw in special tools 11 8 880 and 11 0 235 .
NOTE:
The compression check on all cylinders must
have a constant battery voltage. If necessary, connect an auxiliary battery or charger.
The number of engine revolutions for the compression check must be identical for each cylinder. (The measuring result could be falsified.)
Technical DATA .
The number of engine revolutions for the compression check must be identical for each cylinder. (The measuring result could be falsified.)
Technical DATA .
Assemble engine.
Delete fault memory in the Digital Diesel Electronics.
Check function of Digital Diesel Electronics.