11 31 090 Installing and removing/replacing chain tensioner piston (N55)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove AIR DUCT

Release chain tensioner (1).

Tightening torque: 11 31 7AZ .

IMPORTANT: Have a cleaning cloth ready. A small quantity of engine oil will emerge after the screw connection has been released.
Make sure no engine oil runs onto belt drive.

Fig 1: Draining Oil Chamber Of Chain Tensioner On Level Support

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Replace sealing ring.

If the chain tensioner is used again, the oil must be drained out of the chain tensioner.

Place chain tensioner on a level support and slowly compress.

Repeat process twice.

Fig 2: Identifying Chain Tensioner On Level Support

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.