LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> X3 M40i >> Repair and Diagnosis >> External Pages >> Different car >> Section 428 (Engine - Tightening Torques) >> Variable Valve Gear (N52T) >> 11 37 Variable valve gear

11 37 Variable valve gear

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - VARIABLE VALVE GEAR

  Type Thread Tightening specification Measure
1AZ ASA screws
Guide block to timing case.		 N52T M6 x 23 Only one screw (inside) plus the oil spray nozzle are fitted on cylinder no. 3. 10 Nm
2AZ ASA screws
Torsion spring to cylinder head.		 N52T M6 x 20   10 Nm
3AZ ASA screws
Electric servomotor to cylinder head and to cylinder head cover.		 N52T M6 x 16
  1. Join screws hand-tight to cylinder head.
  2. Join screw hand-tight to cylinder head cover.
  3. Jointing torque on cylinder head.
  4. Jointing torque on cylinder head cover.
 10 Nm
4AZ ASA screw
Oil spray nozzle to guide block.		 N52T M6 x 30 Oil spray nozzle is fitted on cylinder no. 3 (outside). 10 Nm
5AZ Stop screw
Stop screw of eccentric shaft to cylinder head.		 N52T M6   10 Nm
scientia non olet · About LEMON Manuals