11 41 Oil Pump with Strainer and Drive
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - OIL PUMP WITH STRAINER AND DRIVE
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screws Suction pipe to bedplate. |
N52T | M6 x 30 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Torque angle | 100 ° | ||||
| 2AZ | ASA screw Oil pump to bedplate. Aluminum screws/bolts are permitted with and without color coding (blue). |
N52T | M8 x 123 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Torque angle | 180 ° | ||||
| 3AZ | ASA screws Oil pump to bedplate. Aluminum screws/bolts are permitted with and without color coding (blue). |
N52T | M8 x 31 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Torque angle | 90 ° | ||||
| 4AZ | ASA screw Chain module to crankcase. Aluminum screws/bolts are permitted with and without color coding (blue). |
N52T | M6 x 16 | Replace screw. Thread repairs are not permitted! Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Torque angle | 45 ° | ||||
| 5AZ | ASA screws Chain module to oil pump. Aluminum screws/bolts are permitted with and without color coding (blue). |
N52T | M6 x 16 | Replace screws. Thread repairs exclusively with aluminum Helicoil threaded insert. Joining torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Torque angle | 45 ° | ||||
| 6AZ | Fillister head bolt Sprocket to oil pump. |
N52T | M8 x 20 | Jointing torque and angle of rotation must be observed without fail. | |
| Jointing torque | 20 Nm | ||||
| Torque angle | 45 ° | ||||