32 11 100 Replacing gaiter for steering box on left or right

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 BMW X3, 2016 BMW X3, 2015 BMW X3, 2014 BMW X3, and 2013 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The hydraulic steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!

Necessary preliminary tasks:

Remove UNDERBODY PROTECTION .
Remove TRACK ROD END .

Clean track rod.

Release band clamp (1) and EAR CLIP (3).

Detach gaiter (2) from track rod.

Installation note:

Clean rack and check surface for damage (e.g. by corrosion).

Clean track rod and apply grease to taper.

NOTE: This ensures that the gaiter is not rotated when the track rod is rotated.

Fig 1: Identifying Band Clamp, Track Rod And Gaiter

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform CHASSIS/WHEEL ALIGNMENT CHECK .