Install the acoustic cover for the oil sump
- Replace the Christmas tree clip (1).
Parts: Christmas Tree clip
- Position the acoustic cover (2) of the oil pan.
- Mount clips (1) in marked areas.
- Insert and install terminal 50 (4).
- Tighten nut (5).
TIGHTENING TORQUES SPECIFICATION
| Terminal 50 to starter motor | ||
|---|---|---|
| M6 | Tightening torque | 7.5 Nm |
- Insert and install the positive battery cable (1).
- Attach the positive battery cable (1) to the anti-twist lock (2).
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Battery positive lead to starter | ||
|---|---|---|
| M8 | Tightening torque | 13.5 Nm |
- Mount the clip (6).
Follow-up work
- Refer to RAISING THE FRONT AXLE SUPPORT AND FASTEN IT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT ON THE ANTI-ROLL BAR .
- Refer to FASTENING ELECTRIC COOLANT PUMP AND COOLANT HOSES TO THE FRONT AXLE SUPPORT
- Refer to IF INSTALLED: CONNECT THE VACUUM LINE OF THE ENGINE MOUNTS .
- Refer to ATTACHING THE LINE CONNECTION OF THE RIDE HEIGHT SENSOR
- Refer to SECURING THE EPS WIRING HARNESS TO THE ELECTROMECHANICAL STEERING GEAR .
- Refer to INSTALLING STEERING SHAFT AT BOTTOM ON STEERING GEAR
- Refer to INSTALLING THE COVER PANELS ON THE FRONT AXLE ON THE RIGHT AND LEFT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to LOWERING THE ENGINE AND DETACHING THE ENGINE BRIDGE .
- Refer to FASTENING THE ENGINE SUPPORT BRACKETS ON THE ENGINE MOUNTS ON THE LEFT AND RIGHT .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING FUEL DELIVERY LINE .
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE COWL UPPER PART .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .