Installing the oil coolant heat exchanger
NOTE:
TECHNICAL INFORMATION
Make sure that there are no particles or impurities in the medium openings.
Coolant or foreign substances in the oil can cause engine damage such as damage to the connecting rod bearing.
Make sure that there are no particles or impurities in the medium openings.
Coolant or foreign substances in the oil can cause engine damage such as damage to the connecting rod bearing.
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
- Do not use any metal-cutting tools.
- Clean sealing surface (1) on oil-to-coolant heat exchanger.
- Replace all the seals (1).
Parts: Seals
- Install all seals (1).
- Feed in oil coolant heat exchanger (A) and position.
- Tighten screws in the order (1) to (6).NOTE: Tighten the bolts in 360 degree steps.TIGHTENING TORQUES SPECIFICATION
Oil-to-water heat exchanger to full-flow oil filter M6 tightening torque 10 Nm
Follow-up work
- Refer to INSTALLING THE OIL FILTER ELEMENT
- Refer to FILLING ENGINE OIL
- Refer to OPENING THE OIL FILLER CAP
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE RIGHT FRONT-END STRUT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATER TIGHTNESS .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .