Fastening the engine support brackets on the engine mounts on the left and right

NOTE: TECHNICAL INFORMATION
Lower the engine completely to prevent play before bolting down the engine mount and the engine support bracket.

Tighten the screw (1) on the right engine mounting bracket from below.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten screw (1) on the left engine mounting bracket from the bottom using special tool 0 493 751 (11 9 150) .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Install FUEL DELIVERY LINE .
Install IGNITION COIL .
Install rear UNDERBODY PROTECTION .
Install the center UNDERBODY PROTECTION .
Install the left and right hood gasket SEAL .
Install the top left and right engine compartment COVER .
Install rear ACOUSTIC COVER .
Install ACOUSTIC COVER .
Install the upper part COWL .
Install windshield panel COVER .
Install left and right WIPER ARM .
Install the front hood rear SEAL .
Install the rear right engine compartment COVER .
Install the rear left engine compartment COVER .
Reconnect all battery GROUND LEADS
Activate the 48 v ELECTRICAL SYSTEM .
Take hood out of the SERVICE POSITION .