Remove bearing bracket for pedal mechanism
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: 72 00... SAFETY REGULATIONS on handling airbag system components/gas generators
Preliminary work
- Deactivate the 48 v ELECTRICAL SYSTEM .
- Disconnect all battery GROUND LEADS .
- Remove the pedal mechanism TRIM PANEL .
- Remove KNEE AIRBAG .
- Retract release tool 2 409 646 between brake pedal and brake booster.
- Apply support (1) of the release tool 2 409 646
on the bearing bracket. If necessary, position the support by rotating the screw on the release tool.
- Push release tool 2 409 646
in the direction of the arrow and lever out the brake pedal from brake booster.NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
- Disconnect plug connection (1).NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
- Unlock plug connection (1) and disconnect.
- Loosen nuts (1).
- Release screw (1) and remove bearing bracket (2).