Install rear brake pads

• Install the brake pads (1) in the direction of the arrow.
• If necessary for brake pads with adhesive film, detach the protective film.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Equipment version of the design clip: 
• Replace the design clip (1).

  Parts:  Design clip

  The design clip (1) must be replaced after every disassembly.

• Apply the design clip (1) and snap into place with a screwdriver (2) in the direction of the arrow.
• Ensure that the retaining tab (3) is correctly engaged.
• Remove the special tool (cable tie) 2 413 317  .
• Mount brake caliper (3).
• Replace screws (1).

  Parts:  Screws

• Tighten the screws (1), if applicable, hold against the hexagon head (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Guide bolt (brake caliper on brake anchor plate)
  M8	Tightening torque	35 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Install the rear brake pad WEAR SENSOR .
• Install the left and right rear WHEEL .
• START-UP OR BED IN (BREAK)-IN of new brake pads and blades (rear brake).