Install door lock

• Attach the Bowden cable nipple (2).
• Attach the Bowden cable (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the linkage (1) in the door lock (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in the door lock (1) together with the outside door handle support (2) in the door.

  Make sure the new seal from the door lock is not damaged during installation.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed the support (2) into the mounting towards the rear.
• Tighten down screw (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Outside door handle support to door
  screw	Tightening torque	2.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Screw in screws (2), and (3) a few turns.
• First tighten the screws (2).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Door lock to door
  screw	Tightening torque	8.8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Then tighten screw (3).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Door lock to door
  screw	Tightening torque	8.8 Nm

• Clip in locking rod (1).
• Connect and lock the connector (1) on the door lock.

  Fasten the vehicle wiring harness (2) on the door lock and on the outside door handle support.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE POWER WINDOWS .
• Refer to INSTALLING THE OUTSIDE DOOR HANDLE .
• Refer to INSTALLING THE COVER ON THE OUTSIDE DOOR HANDLE .
• Refer to INSTALLING SOUND INSULATION ON FRONT DOOR .
• Refer to INSTALLING FRONT DOOR TRIM PANEL .
• Refer to INSTALLING THE COVER ON THE DOOR HANDLE .