Installing the tandem brake master cylinder
- Insert the tandem brake master cylinder (1) into the brake booster.
- Replace nuts (2)
.
Parts: Nuts
- Place and tighten nuts (2) .
TIGHTENING TORQUE SPECIFICATIONS
| Tandem brake master cylinder in the brake booster | ||
| Replace nuts. M8 |
Tightening torque | 23 Nm |
- Fit brake lines (3) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake pipe screw connection/Union screws | ||
| Tightening torque | 17 Nm | |
Follow-up work
- Refer to INSTALLING THE EXPANSION TANK .
- Refer to INSTALLING THE SYSTEM BATTERY .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .