Install EMF actuator

• Carefully fit the EMF actuator until the gearing engages and the EMF actuator rests flush against the brake caliper.
• If necessary, turn the EMF actuator slightly until the bore hole and the screw thread are aligned.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws 1.

  Parts:  Screws

• Position and tighten the screws (1) at the EMF actuator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1).
• Attach the cable (2) to the bracket.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to AFTER EMF ACTUATOR REPLACEMENT: PUTTING ELECTROMECHANICAL HOLDING BRAKE INTO OPERATION .