Install the roof trim strip
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Check clips (1), seals (2) and supports (3) for damage; replace if necessary.
Clips (1), seals (2) and supports (3) must not be damaged or missing.
- Position the roof trim strip correctly on the roof.
The position of the clips must match the tabs on the roof.
- If necessary, adjust the position of the clips (1).
- Position the roof trim strip (1) in front flush with the roof outer skin.
- Clip in the roof trim strip (1) at the clamps (2).