22 11 011 Replacing left engine mount (N63)

Necessary preliminary tasks:

Secure engine in INSTALLATION POSITION .
Remove rear underbody protection. See 51 47 491 REMOVING REFITTING/REPLACING REAR ENGINE UNDERCOVER .
Lower FRONT AXLE SUPPORT .

Release screw (1).

Tightening torque 22 11 2AZ .

Remove engine mount.

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Rubber Part

Courtesy of BMW OF NORTH AMERICA, INC.