22 11 001 Replacing right engine mount (N63) AWD

Necessary preliminary tasks:

Secure engine in installation position . See 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N63) or 11 00 670 SECURING ENGINE IN INSTALLATION POSITION (N63O1) .
Remove rear underbody protection. See 51 47 491 REMOVING REFITTING/REPLACING REAR ENGINE UNDERCOVER .
Release ENGINE SUPPORT ARM

Release bolt (1) and remove engine mount.

Tightening torque 22 11 2AZ .

IMPORTANT: Installation note:
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).

Fig 1: Identifying Engine Mount Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Rubber part (1) of engine mount must point to center of vehicle.

Fig 2: Identifying Rubber Part

Courtesy of BMW OF NORTH AMERICA, INC.