Overview of tightening torques
| Use in Activity: 31, 33 | |
| Connecting line on cylinder head cover | |
| M6 x 18 | 10 Nm |
| Use in Activity: 32 | |
| Engine wiring harness to engine | |
| M8 | 10 Nm |
| Use in Activity: 34 | |
| Oil filler neck on cylinder head cover | |
| M6 x 20 | 8 Nm |
| Use in Activity: 35, 36 | |
| Carrier plate holder on cylinder head cover | |
| M6 x 20 | 8 Nm |
| Use in Activity: 41 | |
| Expansion tank to body | |
| M6 | 10 Nm |
| Use in Activity: 42 | |
| Oil reservoir to coolant expansion tank/holder | |
| M6 | 8 Nm |
| Use in Activity: 42 | |
| Oil reservoir to wheel arch | |
| M6 x 37 | 10 Nm |
| Use in Activity: 43, 44 | |
| Clean air pie to turbocharger | |
| M6 | 10 Nm |
| Use in Activity: 45, 46 | |
| Charge air hose to exhaust turbocharger | |
| Screw clamp | 3, 5 Nm |
| Use in Activity: 47 | |
| Electronics box, lower section to body | |
| 8 Nm | |
| Use in Activity: 47 | |
| Grounding cable to ground connection | |
| M8 | 21 Nm |
| Use in Activity: 49 | |
| Clamp to air duct | |
| 3 Nm | |
| Use in Activity: 51 | ||
| Suspension cross-brace in engine compartment, front | ||
| M10 x 25 | Tightening torque | 56 Nm |
| M10 x 47 | Jointing torque | 30 Nm |
| Replace screws | Angle of rotation | 90 ° |
| Use in Activity: 54 | |
| Battery earth lead | |
| M6 | 5 Nm |