17 11 035 Removing and installing/replacing fan cowl with electric fan (N55)

Necessary preliminary work:

Release screw (1) on fan cowl.

Tightening torque 17 10 4AZ .

Detach charge air duct (2) from fan cowl.

Fig 1: Identifying Charge-Air Duct And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl on right.

Fig 2: Identifying Connector On Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at clamps (2) on left and right, feed out in upward direction and remove.

Fig 3: Identifying Fan Cowl And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (1) at bottom on module carrier.

Fig 4: Identifying Retaining Tab

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Delete fault memory.