Install the rear window

• Clean the bonding surfaces on the body and the rear window.
• Keep 2 glue cartridges ready.
• Prepare a glue cartridge with the standard nozzle C.
• Apply bead joint in area (1).
• Apply adhesive bead within the mark (2) on the rear window.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Open the tailgate (1) by approximately 1/3 and secure it in this position.
• Using suction lifters, carefully guide the rear window (2) parallel to the C-pillar and thread it in below the tailgate.
• Carefully fir the rear window (2) with the suction lifters at the top and align is evenly sideways.
• Using suction lifters, carefully press the rear window (2) upwards until the seal has uniform contact with the roof.
• Press the rear window (2) carefully with suction lifters evenly all around and adjust the gap dimension.

  Courtesy of BMW OF NORTH AMERICA, INC.

  TECHNICAL DATA SPECIFICATION
  
  

  Gap dimension rear window to roof outer skin
  1 rear window; 2 roof a  outer skin Courtesy of BMW OF NORTH AMERICA, INC.	4.0 +1 3-1.3 mm 2.6 +1.3-1.3 mm

• Measure the recess (A) of the rear window (1) to the roof outer skin (2) with the special tool  0 495 259 (51 0 010)  .

  Measure the gap dimension (B) with the special tool 0 496 076 (00 9 470). 

• Secure rear window (1) with adhesive tap on the roof.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fix the cable (2) with the nuts (1) on to the attachment point.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen cable (2) from the rear window.
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE AUXILIARY STOPPING LAMP .
• Refer to INSERT TRIM FOR AUXILIARY BRAKE LIGHT .
• Refer to INSTALLING BOTH C-PILLAR TRIM PANELS .
• Refer to INSTALLING THE TRIM PANEL FOR THE REAR LEFT AND RIGHT WATER CHANNEL .