Install the rear top cross connection
- Position the cross connection at the upper rear (4) and guide in.
- Snap the cable clip (3) into the cross connection at the upper rear (4) .
- Tighten down screws (2)
.TIGHTENING TORQUE SPECIFICATIONS
Top rear cross connection center Tightening torque M8x20 screw 28 Nm - Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATIONS
Top rear cross connection at side Tightening torque M8x30 screw 19 Nm
Follow-up work
- Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .