Carrying out ride height adjustment
NOTE:
Ride height adjustment must be carried out after the following work:
- Removal/replacement of ride height sensor or its control rod (only necessary on vehicles with air suspension)
- Exchange the EHC control unit (only with F01/F02/F03/F04/F07)
- Replacement of ICM control unit (Integrated Chassis Management)
Connect diagnosis system.
Switch the ignition on.
Carry out ride height adjustment (menu item: "Service function").
Attention!
Following ride height adjustment, for vehicles with:
- Run Flat Indicator: Initialize RUN FLAT INDICATOR .
- Tire Pressure Monitor: Perform TIRE PRESSURE CONTROL (RDC) RESET .