Service-vehicle check

• Service - vehicle check 

Passenger compartment: 

• Check HORN, HEADLIGHT FLASHERS AND HAZARD WARNING FLASHERS .
• Check INSTRUMENT AND INSCRIPTION LIGHTING, PASSENGER COMPARTMENT AND GLOVEBOX LIGHTING, BLOWER .
• Check LIGHTING SYSTEM : if necessary, adjust the headlights, function of front and rear lights and number plate lights, which will be charged for separately
• Check SEAT BELTS 
• Check CHECK WINDSCREEN WIPER AND WASHER SYSTEM FOR FUNCTION AND SETTING .

Rear/tires  :

• Check TIRES  (including compact spare wheel if present):
  • Tread depth
  • Tread wear pattern
  • External condition
  • Check inflation pressure and correct if necessary.

Observe the information on tolerance compensation for RDC.

• If fitted:

BMW Mobility Set: Check expiry date on the tire sealant bottle. Replace tire sealant bottle, if necessary (charge separately).

• Check that warning triangle, high-visibility jacket and first-aid kit are present. Check expiry date on first-aid kit (observe national legislation where applicable).
• Initialize RUN FLAT INDICATOR or TIRE PRESSURE CONTROL .
• Check the factory setting {STREET} on the rear spoiler.

If not in the factory setting: Point out to the customer that the vehicle is permitted to be driven on public streets only with factory settings.

Engine compartment  :

• Check COOLANT LEVEL AND CONCENTRATION , top up where necessary (check both coolant levels on F01, F02, F10 and F30 hybrid cars). Inform customer in event of incorrect fluid level and, if necessary, troubleshoot (charged separately).
• WASH/WIPE SYSTEM : Check the fluid level and top up if necessary.

Underfloor: 

• BRAKE LINES AND CONNECTIONS : Check for tightness, damage, mounting and correct position
• VEHICLE UNDERBODY  including all visible components: Check for damage, correct position, tightness and corrosion
• STEERING COMPONENTS : Check for play, tightness if applicable, damage and wear
• Check the factory setting on the front splitter: The front splitter must be mounted in the direction of the vehicle, at the limit position at the rear.

If not in the factory setting: Point out to the customer that the vehicle is only permitted to be driven on public streets with factory settings.

• Check the factory setting on the chassis: Check if the C-clips on the front and rear axle are mounted and if the circlips are installed with torn set screws.

If not in the factory setting: Point out to the customer that the vehicle is only permitted to be driven on public streets with factory settings.

• Check the springs for corrosion and if necessary, replace and charge separately
• Check front axle support bearings for play and replace if necessary and charge separately
• Check stop pads and protective tubes for damage and replace if necessary and charge separately
• Check screw connections, shock absorbers/support bearings on the front and rear axles
• Check remaining brake pad thickness
• Check brake disc thickness
• Check brake discs for crack formation (beginning at the holes)
• Check dust boots of the brake calipers for damage

Test drive  :

• Check for road safety:
  • Brakes
  • Steering
  • Shock Absorbers
  • Transmission

• Reset CBS DISPLAY  according to factory specification
• Carry over maintenance works in electronic service booklet  .