LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> General Information >> OEM General Information >> M4 Technical Data -- M4 (F82 & F83) >> Front Brakes

Front Brakes

F82 COUPE: 

FRONT BRAKE F82 SPECIFICATIONS

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension (see table).
Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!
(Not applicable to perforated brake discs and M vehicles).
Applies only to M vehicles and perforated ventilated brake discs:
The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!
Depending on:
  • Engine type
  • Transmission version
  • Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.) different brake discs can be fitted
The brake discs must always be assigned by way of the relevant vehicle identification number.		    
Different thicknesses on brake linings Max. mm 0.01
Minimum brake disc thickness stamped on brake disc chamber mm 28.4
Nominal size (diameter x thickness) mm 380x30
Pad wear warning from remaining brake pad thickness mm 3.7

F83 CONVERTIBLE: 

34 11 FRONT BRAKE F83 - TECHNICAL DATA SPECIFICATION

IMPORTANT: Installation of new brake pads is approved only provided that the brake disc thickness exceeds the specified dimension (see table).
Brake discs must be replaced when they reach the nominal thickness (see table) minus 2.4 mm!(Not applicable to perforated brake discs and M vehicles).Applies only to M vehicles and perforated ventilated brake discs:The brake discs must be replaced once they wear to the nominal specified thickness (see table) minus 1.6 mm!.Depending on:
  • Engine type
  • Transmission version
  • Equipment specification (e.g. maximum load increase, chassis official-use, national version, etc.)
different brake discs can be fittedThe brake discs must always be assigned by way of the relevant vehicle identification number.		    
Different thicknesses on brake linings Max. mm 0.01
Minimum brake disc thickness stamped on brake disc chamber mm 28.4
Nominal size (diameter x thickness) mm 380x30
Pad wear warning from remaining brake pad thickness mm 3.7
scientia non olet · About LEMON Manuals