Glues and their minimum hardening times:
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
GLUES MINIMUM HARDENING TIME
| Glue | Minimum hardening time "without passenger airbag" (after which vehicle can be moved) | Minimum hardening time "with passenger airbag" (countries where seatbelt use is not required by law) |
| Hot processing with accelerator | 2 hours | 3 hours* |
| Cold processing | 9 hours | 20 hours* |
NOTE:
Vehicles with passenger airbag:
The vehicle can be handed over to the customer after the hardening period (vehicle can be moved, adhesive-dependent) with the following warning:
Once the windscreen glass has been bonded, all occupants must travel with their seatbelts attached for "... hours"!
The time is taken from the "Minimum hardening period" table for countries where seatbelt use is not required by law.
The vehicle can be handed over to the customer after the hardening period (vehicle can be moved, adhesive-dependent) with the following warning:
Once the windscreen glass has been bonded, all occupants must travel with their seatbelts attached for "... hours"!
The time is taken from the "Minimum hardening period" table for countries where seatbelt use is not required by law.
IMPORTANT:
If the minimum hardening time is not adhered to:
- the front passenger together with the windscreen may fall out of the vehicle in the event of an accident after the front passenger airbag has been triggered