16 00 102 Checking fuel tank and tank venting system for leaks with tank leakage diagnosis module (DM-TL)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
An OBD fault is indicated by the "Check Engine" indicator lamp in the instrument cluster lighting up. This may indicate a leak in the tank venting system. Information on this is provided by the fault memory of the DME control unit.
- Read out fault memory of DME control unit and carry out a diagnosis in accordance with faults stored.
- A leak test with the DM-TL module is then carried out if:
- The components of the DM-TL module are OK.
- A error is stored in the DME fault memory (tank leak detected).
Adhere to following conditions in order to carry out a correct leak test:
- Content of fuel tank < 90%
- Reserve indicator lamp "off"
- Leave car in workshop for at least 2 hours so that fuel temperature comes into line with workshop temperature (ideal fuel temperature approx. 10...20°C).
- Do not under any circumstances fill up car with fresh fuel (strong exhalation of fresh fuel).
- Check that tank cap is correctly seated.
WARNING:
During the leak test, under no circumstance apply external pressurization through the tank filler neck as this may cause incorrect readings.
Clear DME fault memory.
In the Diagnosis and Information System (DIS), go to the "Function and component selection" page.
By selecting:
- Complete vehicle
- Drive
- Engine management
- Tank system test
- Diagnosis module tank leakage (DMTL)
adopt test module in test schedule.
Switch to the test schedule and implement the tank leakage diagnosis module. Leakage test is carried out.
If fault is recorded again in DME fault memory (tank leak detected), carry out leak test. See 16 00 510 Conducting leak test on fuel tank and tank ventilation system