11 36 570 Replacing solenoid valve for inlet side on VANOS adjustment unit
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 32 2 110
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Check stored fault messages
- Switch off ignition
Unlock hose (1) and detach.
Unlock plug (2) and remove.
NOTE:
Once it has been removed, oil drips from the solenoid valve.
Have a cleaning cloth ready.
Make sure no oil drips onto the belt drive. Remove any remnants of oil immediately with cleaning cloth.
Do not damage oil line when releasing solenoid valve.
Release solenoid valve with special tool 32 2 110.
Installation:
Tightening torque. Refer to ENGINE - TIGHTENING TORQUES - 3-SERIES (E46) .
Now clear the fault memory.