11 22 513 Replacing roller bearing for dual-mass flywheel

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2006 BMW 330Ci, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2004 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

21 2 051
21 2 052

NOTE: Flywheel removed!

Using hydraulic press (1) and special tool 21 2 051. press out dual-mass flywheel downwards on engine side.

IMPORTANT: Risk of damage:
Roller bearing must not be driven out.

Fig 1: Pressing Out Dual-Mass Flywheel Downwards

Courtesy of BMW OF NORTH AMERICA, INC.

Push roller bearing (2) onto special tool 21 2 052.

Using hydraulic press (1), press roller bearing into dual-mass flywheel as far as it will go on clutch side.

IMPORTANT: Risk of damage:
Observe press-in instruction:

Fig 2: Pushing Roller Bearing Onto Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Roller bearing must not be driven in.
Roller bearing mounting force/travel monitored:

Min. 2000N 1 mm before end of pressing in.

Max. 15000N during entire press-in procedure.