Replacing Wiring Harness In Automatic Transmission (A5S 360R/390R, A4S 200R)

WARNING: This page does not describe the selected car, but rather 49 other vehicles, including the 2007 BMW Z4, 2007 BMW X3, 2006 BMW Z4, 2006 BMW X5, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Numbers in text refer to numbers in figures.

NOTE: After completing work, top up ATF level. Check/top up fluid level in automatic transmission. See CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (A5S 360R / 390R, A4S 200R / 310R) .

Remove transmission oil sump. See REMOVING AND INSTALLING/SEALING OR REPLACING TRANSMISSION FLUID SUMP (A5S 360R / 390R, A4S 200R) .

Remove transmission plug at rear right.

Pull off transmission fluid screen (1) towards bottom and remove. See Figure .

NOTE: If the sealing ring (1) has remained in the pump housing, it must be removed and the transmission fluid screen replaced. See Figure .

Disconnect all plug connections on shift unit. Unclip temperature sensor (1) from holder. See Figure .

NOTE: As of model year 2001 (04/2000), the temperature sensor is integrated in the wiring harness.

Remove retaining clip with screwdriver (2). See Figure . Insert transmission plug (1) in transmission. Remove wiring harness from automatic transmission.

Installation: to facilitate installation, coat sealing rings with petroleum jelly. See Figure . Make sure transmission plug is in correct position.