LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Bag Deactivation Procedures) >> SUZUKI >> Disabling & Activating Air Bag System >> Activating Air Bag System (Aerio)

Activating Air Bag System (Aerio)

WARNING: This page does not describe the selected car, but rather 173 other vehicles, including the 2003 Volvo XC90, 2003 Volvo XC70, 2003 Volvo V70, 2003 Volvo V40, and 2003 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that negative battery cable is disconnected. Turn ignition switch to LOCK position and remove ignition key. Connect driver's side Yellow connector of air bag contact coil and combination switch assembly by pushing connector in until a click is heard. Connect passenger's side Yellow connector of passenger's air bag module by pushing connector in until a click is heard. Ensure all other air bag components are properly installed and connected.
    2. CAUTION: When turning ignition switch to ON position stay as far away from air bag deployment travel as possible.
  2. Install glove box. Install AIR BAG fuse in fuse box. See Figure. Connect negative battery cable. Turn ignition switch to ON position and verify that AIR BAG warning lamp flashes 6 times and then turns OFF. If it does not operate as described, perform Air Bag Diagnostic System Check.
scientia non olet · About LEMON Manuals