LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Bag Deactivation Procedures) >> HONDA >> Disabling & Activating Air Bag System >> Disabling Air Bag System (Accord)

Disabling Air Bag System (Accord)

WARNING: This page does not describe the selected car, but rather 173 other vehicles, including the 2003 Volvo XC90, 2003 Volvo XC70, 2003 Volvo V70, 2003 Volvo V40, and 2003 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Obtain radio anti-theft code from vehicle owner and write down preset radio frequencies. Ensure ignition is OFF. Disconnect negative battery cable. WAIT at least 3 minutes.
  2. Remove access panel from under steering wheel. Disconnect 4-pin connector between driver's air bag and cable reel. See Figure and Figure .
  3. Remove glove box. Disconnect 4-pin connector between passenger's air bag and SRS main harness. See Figure and Figure . When disconnected, air bag connector half power and ground terminals are automatically shorted together.
  4. Disconnect side air bag module 2-pin connectors for driver's and passenger's side impact air bag modules. On driver's side, connector is near front, lower left corner under seat. On passenger's side, connector is near front, lower right corner under seat. See Figure.
  5. On sedan models, remove left and right "B" pillar lower trim panels. On coupe models, remove rear side trim panels. On both models, disconnect 2-pin connector between both front seat belt pretensioners and SRS main harness. See Figure. When disconnected, seat belt pretensioner connector power and ground terminals are automatically shorted together.
  6. If equipped with side curtain air bag assembly, remove rear pillar trim panels. Disconnect both side curtain air bag inflator 2-pin connectors. See Figure.
scientia non olet · About LEMON Manuals