LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Bag Deactivation Procedures) >> HONDA >> Disabling & Activating Air Bag System >> Activating Air Bag System (Pilot)

Activating Air Bag System (Pilot)

WARNING: This page does not describe the selected car, but rather 173 other vehicles, including the 2003 Volvo XC90, 2003 Volvo XC70, 2003 Volvo V70, 2003 Volvo V40, and 2003 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.
  1. Ensure ignition is OFF and negative battery cable is disconnected for at least 3 minutes. Connect 4-pin driver's air bag module connector to cable reel connector. Install access panel under steering wheel.
  2. Connect 4-pin passenger's air bag module connector to SRS harness connector. Install glove box. Connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels. Connect driver's and passenger's side impact air bag module 2-pin connectors under seats.
  3. Ensure ignition is off. Connect negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Reset radio anti-theft code and reprogram radio frequencies. The idle learn procedure must be performed so the PCM can learn engine idle characteristics. To perform idle learn procedure, go to next step.
  4. NOTE: If radiator cooling fan comes on, add the time the cooling fan is on to the 5 minute adaptive idle learn time.
  5. Ensure all electrical loads (A/C, audio, rear defogger, lights, etc.) are turned off. Start engine, and hold it at 3000 RPM with no load (in Park or Neutral) until radiator fan comes on, or until engine coolant temperature reaches 194°F (90°C). Allow engine to idle for about 5 minutes with throttle fully closed and cooling fan not operating.