LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Bag Deactivation Procedures) >> ACURA >> Disabling & Activating Air Bag System >> Activating Air Bag System (3.2TL)

Activating Air Bag System (3.2TL)

WARNING: This page does not describe the selected car, but rather 173 other vehicles, including the 2003 Volvo XC90, 2003 Volvo XC70, 2003 Volvo V70, 2003 Volvo V40, and 2003 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: To reconnect front SRS connector, push sleeve-side connector half toward pawl-side connector half without touching sleeve. As connector halves are pressed together, pawl will push sleeve back. When connector halves are completely connected, pawl will release spring-loaded sleeve and lock connector.
  1. Ensure ignition is OFF and negative battery cable is disconnected for 3 minutes. Connect 4-pin driver's side air bag connector to cable reel connector. Install access panel under steering wheel.
  2. Connect 4-pin passenger's air bag connector to SRS harness connector. Install glove box. Connect driver's and passenger's side impact air bag module 2-pin connectors under seats. Connect both front seat belt pretensioner connectors to SRS main harness.
  3. Ensure ignition is off. Connect negative battery cable. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK . Before returning the vehicle to the customer, enter navigation and radio anti-theft codes, then enter the customer's radio station presets, and set the clock.
Fig 1: Disabling Passenger's Air Bag (3.2TL Shown; 3.2CL Is Similar)
G99G00188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002