LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Differentials & Axle Shafts) >> Removal & Installation >> Rear Hub & Carrier Assembly >> Removal (3-Series)

Removal (3-Series)

WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 BMW Z8, 2000 BMW Z3, 2000 BMW X5, 2000 BMW M5, and 2000 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect parking brake cables on parking brake lever. Remove rear wheels. Remove exhaust system. Disconnect drive shaft from differential. See DRIVE SHAFT  . Remove left and right brake line retaining bolts. Remove brake calipers, and wire aside. Remove ABS impulse sensors.
  2. Support trailing arm with a jack. Remove lower shock bolts, and lower jack. Remove speedometer signal sensor (if equipped). Unbolt and remove heat shield and bracket. See Figure . Pull parking brake cables from guides. Remove trailing arm bolts. Position Rear Axle Retainer (00 2 030, 00 2 040, 33 3 290) under rear axle. Remove rear axle carrier bolts. See Figure . Slowly lower jack. Remove springs.
scientia non olet · About LEMON Manuals