Removal (With Rear Universal Joint)
WARNING: This page does not describe the selected car, but rather 29 other vehicles, including the 2000 BMW Z8, 2000 BMW Z3, 2000 BMW X5, 2000 BMW M5, and 2000 BMW M Roadster. However, it is still accessible from the selected car via links, so may be relevant.
- Remove exhaust assembly and heat shield. Remove exhaust assembly mounting brackets. On models with joint disc, remove 3 bolts, and disconnect joint disc at transmission. See Fig 1 . On models with universal joint, disconnect universal joint at transmission. See Fig 2 .
- On all models, loosen threaded sleeve with Wrench (26 1 040). Mark position of universal joint relative to differential pinion shaft. Disconnect universal joint at differential. Unbolt drive shaft center mount. Lower drive shaft at center mount. See Fig 3 . Pull off centering pin at transmission or differential (if equipped). Remove drive shaft.